Intro All electronics will fail with age.  A significant chunk of the failures are due to electrolytic capacitor failure.  These components are virtually guaranteed to fail eventually, even under normal use circumstances.  There are even calculators that can help you estimate how long a given capacitor will last! So why do manufacturers use these components […]

Introduction The hardware portion of the NEMU tuning package requires installation in an ECU to be functional.  This install is NOT for beginners, although it is not extremely difficult with the correct tools.  This article will walk you through the install from start to finish with lots of pictures along the way.  If you still […]

You will need bridge J1 on the back of the ECU. Add C49 & C50 and C91 & C92 on back C49 & C50 –> .004UF (Digikey part number 399-1230-1-nd ) C91 & C92 –> .00001UF ( digikey Part Number 399-1192-1-nd ) Add the 74hc373 SMD chip. (MFG part# SN74HC373NSR, Digi-Key Part Number 296-8310-1-ND) Add […]

This is Keebler65’s old guide. Some of the chipset and software info is a bit dated, but the techniques are good. ECU Chipping You need to add a few additional components to the original Honda ECU. It requires some soldering skills and should not be attempted unless you have soldered before. (Chances are you know […]

Hulog/Hondalog Installation of Honda-Based USB Datalogging Tools There are two tools available for datalogging on Honda ECUs from www.moates.net and they include the HULOG and the HondaLog. HULOG: The HULOG comes in a plastic enclosure and ONLY requires a pin swap if it is an older unit. All the new units come with 1:1 connector […]

G2 G2 TBI-Style 2732-to-29C256 Adapter Installation Instructions:Here is a pictorial depiction of a G2 installation in a TBI-style ECM. It shows the following: 1) Disassembly and removal of stock socket body. – Take note of the ‘stock’ 2732A chip orientation. Your 2732A chip will probably be in a little plastic holder. – Try and overcome […]

Versions This is the documentation for the Nissan Boards.  At this point, there are only one version of the boards, 1.1nm  As future revisions to the board are produced, this page will be updated. Applications These boards are designed for S13 and B13 applications.  They will NOT work with S14a ECUs that have a 20×2 […]