The Burn1 is a revolutionary device that was designed with the automotive enthusiast in mind. it supports chips used in our products aimed at ECUs/ECMs from the late 80s and early 90s.

The BURN1 can:

• WRITE SST 27SF512, ATMEL AT29C256 and 29F040 chips.
• READ but NOT WRITE 2732A, 27C128, 27C256 chips (and most other 24/28 pin EPROMs/EEPROMs that can replace one of these chips).
• With a F2A adapter, it can WRITE our F3 EECIV/EECV chip modules.
• With a F2E adapter, READ factory Ford ECMs.
• with a HDR1 adapter, READ factory GM TPI ECMs that would use a G1 chip adapter .

As you can see, it is designed to comprehensively work with our products but it is NOT a general purpose EPROM programmer.  If you require programming chips outside these specifications, you probably should look at another product.

Before the Burn1 was developed, there were only a handful of chip burners known to be compatible with these chips. These burners were usually not cost-effective, used outdated PC interfaces like a parallel Printer port. They also required external power supplies, so forget burning on the fly. Examples include the $160 Pocket Programmer II.

The Burn1 was revolutionary with its simple USB interface that provided all power to the unit. An internal DC voltage step-up circuit is used to provide the high erase voltage required on certain chips.

The latest generation of the Burn1 is the Burn2. It has the same same command set and features as the Burn1 but has a smaller size.

How to Buy

This product has been replace with the Burn2. Please visit the Burn2’s page on our webstore here