Introduction Ever wish your favorite Moates emulator would work with your favorite ROM editor software that doesn’t have native support for our products?  EmUtility (from the author of TunerPro) allows you to use Moates emulators with any software that can spit out a binary (bin) or hexadecimal (hex) format file.  It supports the Ostrich1, Ostrich2, [...]

Introduction The Demon is the newest in our line of Honda/Acura-friendly P28/P30/P72-compatible technology. Flawless realtime emulation, embedded datalogging, auxiliary ports, 16x calibration storage and encryption.   The Demon is designed to fit inside both USDM and JDM ECUs including those with knock boards.   The Demon combines the features of the Ostrich, Hulog, RTP, and adds its [...]

Bluetooth For the Ostrich2, the following will show you how to install the Bluetooth into the unit: 1) Open the Ostrich (two screws), keep track of the two nylon spacers. 2) Gather up the Bluetooth kit parts as shown in the pictures below. 3) Place the pin headers on the Bluetooth module and snap them [...]

The RoadRunner is the only available full blown emulator for LS1 PCMs – unlike other “emulation” software, the entire contents of the flash is emulated Real-Time, not just certain maps.  It can also be used as a general purpose emulator in custom applications (Bosch Motronic, Nissan, …) Hardware Available At this point, there are two [...]

Neptune is a tuning hardware/software package developed by James Holy that also supports a great deal of features. The Neptune board was designed by Moates. More information can be found at the official Neptune site here

The Autoprom was the first Moates device. It is a combination Emulator, Chip Burner and Datalogger. Today you can buy these devices separately, however this package eliminates the need for 3 separate units. Compatibility As of writing this article, the only software known to be fully compatible with the Autoprom is TunerPro RT.  TunerCat OBD1 [...]

The Ostrich 1.0, which has now been discontinued, was the first in the Ostrich line. Upon the creation of the first Moates product, the Autoprom (APU1) the team at Moates quickly realized the demand for seperation of the Burner/Emulator/Datalogger combo. As a result, the Ostrich 1.0 was born. Early versions of the Ostrich 1.0 were [...]

The release of the Ostrich 2.0 was the marking point for the next generation of Moates products. Along with a 75% size reduction, the Ostrich 2.0 also boasts many firmware advances. The Ostrich 2.0 connects to the host computer with a baud rate of 921,600bps, which is the fastest bit rate supported by standard RS-232. [...]

About the QuarterHorse The QuarterHorse delivers in unparalleled fashion. It gives you absolutely bumpless, 100% realtime tuning AND realtime datalogging for all EEC-IV and EEC-V through 2004. It plugs into the J3 port like a chip, but its capabilities are stunning. This is just the hardware, and limitations of vehicle coverage are dependent on software packages available separately [...]